The way is to use LCNC tetrapod just for 3D flying, then the object has its special movements controlled wireless using Arduinos, dsPics and a PC. I'm working in this months on a java based software to control up to 16 motors in LAP PWM changing for each motor Accel, Decel, Speed and Position. But still need some improvement..
Thanks! Davide. p.s. it's not a bear, but a green ippo... :) Il giorno ven, 08/02/2013 alle 22.25 +1100, Erik Christiansen ha scritto: > On 08.02.13 11:00, Spiderdab wrote: > > Some of you already know my "inverted tetrapod". Here is a little > > demonstration I did some time ago on a real stage during a pause. > > I just wish it may be be nice to watch. > > It was - and leads to some musing. If the bear were to make some ballet > leaps, it would be good to raise the arms. A second inverted tetrapod, > with wires from its apex to each hand, could perhaps do that? But could > one LinuxCNC control both? > > Erik > -- Se non puoi aggiustare una cosa, non รจ tua. If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Free Next-Gen Firewall Hardware Offer Buy your Sophos next-gen firewall before the end March 2013 and get the hardware for free! Learn more. http://p.sf.net/sfu/sophos-d2d-feb _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
