Greg, We swapped the 7i33 card out with another and checked the connections as much as we could.
On 2013/05/05 01:18 AM, Gregg Eshelman wrote: > --- On Sat, 5/4/13, Marius Liebenberg <[email protected]> wrote: > >> From: Marius Liebenberg <[email protected]> >> I run 2.5.2 on that machine. As I mentioned before, I did >> change the >> motor/encoder but the problem stays. I thought it might be a >> damaged >> encode because it only effects the feedback in one >> direction. >> Is halscope the only way to see what the cause could be? It >> might be >> difficult to see because the error is +/- 1% of the total >> travel and in one direction only. > What about the wire connection at the controller? Could even be something as > mundane as a bad solder joint on the connector or terminal block. > > -- Regards / Groete Marius D. Liebenberg MasterCut cc Cel: +27 82 698 3251 Tel: +27 12 743 6064 Fax: +27 86 551 8029 Skype: marius_d.liebenberg Skype Me^(TM)! <skype:marius_d.liebenberg?call> Get Skype <http://www.skype.com/go/download> and call me for free. --- avast! Antivirus: Outbound message clean. Virus Database (VPS): 130504-0, 2013/05/04 Tested on: 2013/05/05 09:44:54 AM avast! - copyright (c) 1988-2013 AVAST Software. http://www.avast.com ------------------------------------------------------------------------------ Get 100% visibility into Java/.NET code with AppDynamics Lite It's a free troubleshooting tool designed for production Get down to code-level detail for bottlenecks, with <2% overhead. Download for free and get started troubleshooting in minutes. http://p.sf.net/sfu/appdyn_d2d_ap2 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
