All,
A couple of years ago I retrofitted a Cincinnati Milacron Cim-X
milling center with EMC2. Due to an operator error this machine is no longer
mechanically serviceable. I have the following for sale that was pulled from
the machine:
1. Vital Systems Motenc-Lite Servo Controller and all daughter boards
and cables. The daughter boards were used for the operator station only for
pushbuttons and led bulbs for the pushbuttons. I also have the servo
daughter board.
2. Automation Direct Sure Servo drives and servo motors (3KW). The
motors have 2500 ppr encoders. The drives have an output of the position
pulses for semi closed loop operation. That is how I used them and it worked
great. You would need to purchase encoder and motor cables or roll your own.
They have many different lengths. I do have the daughter boards and cables
for the drives. All is in very good condition. Continuous duty on the motors
are 15 nm and intermittent is about 46 nm. I also have the cable and tuning
software for the drives.
3. I also have a Mesa Electronics 5i20 that I used for the general
purpose I/O.
4. I have several opto 22 boards that were used for the GPIO. It's a
pretty good mix so you tell me what you need and I will tell you if I have
it.
I have some other things lying around I hope to list. Make me offers for one
or all. Thought I would give the people who know what this stuff is a chance
at it before it hits auction. I need to buy some heavier stepper motors and
drives for my router. The control was air conditioned in a climate
controlled shop so all is pretty clean.
You can message me off site at [email protected].
Thanks,
Paul
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
