Dear LinuxCNC users, I would like to announce hf2gcode, which is a hershey font to g-code tracer. You can find hf2gcode in the following link: https://github.com/Andy1978/hf2gcode
Here is a generated sample g-code: http://pastebin.com/DHMNg8ZF I have written this primary for its use on an AVR microcontroller, but I also added a CLI so it can be used on any PC. Any comments or suggestions are welcome. jdh from #LinuxCNC on freenode already suggested a param for the spindle speed (it's fix "M3 S10000" at the moment) and a "save z-height to start of the first character". Best regards, Andy PS: I think my first post to the list was not accepted because I havent yet confirmed my subscription. I have to apologize if this doubles the post. ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
