On 28 June 2013 17:55, Hugh Currin <[email protected]> wrote: > I spent a few minutes trying to configure it to use the PCI parallel > card rather than the onboard parallel port. I found the card (lspci -v) > but couldn't get it configured in LinuxCNC. The I/O ports are at 1000, > 1010, 1018, 1020, 1028, & 1030 but I may have a format error when I > enter these into the HAL file.
Try 0x1000 (the addresses are in Hex). I am not sure what the problem is with the built-in parport though. You could try inverting the pins on the parport? -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
