That must not be what i'm looking for. The latest entry is -- Chris Radek <[email protected]> Sun, 03 Mar 2013 17:07:57 -0600 which does not show the changes i received when i did a "git pull" yesterday. Where is the log that shows what was updated then?
Thanks, Shannon Watson [email protected] Phone: (316) 945-1227 MPM Inc. 2100 S West Street Wichita, KS 67213 > On 7/10/13 08:23 , Shannon Watson wrote: >> Is there a change log of log file to review when there are updates to the >> GUI's and/or LinuxCNC? > > When you install the debian package you get a changelog installed in > /usr/share/doc/linuxcnc/changelog. > > > The same info is also on the wiki: > > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Released > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Released_2.5.X > > > When upgrading across major versions (for example from 2.4 to 2.5), > there may sometimes be config changes needed, these are recorded here: > > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?UpdatingTo2.5 > > > Is this what you had in mind? > > > -- > Sebastian Kuzminsky > > > > ------------------------------ ------------------------------------------------------------------------------ See everything from the browser to the database with AppDynamics Get end-to-end visibility with application monitoring from AppDynamics Isolate bottlenecks and diagnose root cause in seconds. Start your free trial of AppDynamics Pro today! http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
