Thanks Dave, 300 for xyz is much better than 300 for just the x
Terry ----- Original Message ----- From: dave <dengv...@charter.net> To: Terry Christophersen <tcninj...@yahoo.com>; Enhanced Machine Controller (EMC) <emc-users@lists.sourceforge.net> Cc: Sent: Monday, August 12, 2013 9:27 PM Subject: Re: [Emc-users] sem motors On Mon, 2013-08-12 at 19:14 -0700, Terry Christophersen wrote: > Hi all, > I am reretrofitting a bridgeport that I use for second operations.It has 250 >line encoders now. > I would like to upgrade these encoders to say 500 or 1000 line(I am getting > rid of the 2:1 > ratio pulleys and going for 1:1 so I have lost 1/2 of my resolution) > I dont need heidenhains or super expensive ones as this machine is not used >on > a daily basis. > Motor: > > SEM MT30-R4 31lb/in > > I dont care if it mounts under the cover like the old one or is outside on > the end of the shaft. > The orginals were 3 piece(light,wheel,pcb with sensors all open) > > > Any sources? > > Thanks > > Terry I've had good luck with these: Automation Direct Koyo TRD-S2500-VD ENCODER 2500 PPR 6mm SOLID LINE- DRIVER 5VDC 2m (6.5ft) CBL LT DUTY $90 Use them on the cinci and the Mazak. Dave > ------------------------------------------------------------------------------ > Get 100% visibility into Java/.NET code with AppDynamics Lite! > It's a free troubleshooting tool designed for production. > Get down to code-level detail for bottlenecks, with <2% overhead. > Download for free and get started troubleshooting in minutes. > http://pubads.g.doubleclick.net/gampad/clk?id=48897031&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Get 100% visibility into Java/.NET code with AppDynamics Lite! It's a free troubleshooting tool designed for production. Get down to code-level detail for bottlenecks, with <2% overhead. Download for free and get started troubleshooting in minutes. http://pubads.g.doubleclick.net/gampad/clk?id=48897031&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
