Jack In this case Google is your friend. There are literally thousands of ideas from guys who have done their own thing. Two things I recommend that you don't do without. 1: You must fit a THC of sorts. Especially if you are going to cut thinner materials. 2: You must fit a water bed for your own health's sake. Also you can minimize the warping if you cut in water.
Do a table that can cut a full sheet. The cost will not be that much more. Most of the cost goes into the linear devices and the control system (drivers, motors etc) On 2013/09/06 04:47 AM, Jack Coats wrote: > Has anyone done a DIY plasma table, or have suggestions I could find > out about a DIY version? > > I am a rookie and just learning, wanting to find out if it could be > practical for a hobby setup. > > TIA, Jack > > ------------------------------------------------------------------------------ > Learn the latest--Visual Studio 2012, SharePoint 2013, SQL 2012, more! > Discover the easy way to master current and previous Microsoft technologies > and advance your career. Get an incredible 1,500+ hours of step-by-step > tutorial videos with LearnDevNow. Subscribe today and save! > http://pubads.g.doubleclick.net/gampad/clk?id=58041391&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Regards / Groete Marius D. Liebenberg MasterCut cc Cel: +27 82 698 3251 Tel: +27 12 743 6064 Fax: +27 86 551 8029 Skype: marius_d.liebenberg --- avast! Antivirus: Outbound message clean. Virus Database (VPS): 130905-1, 2013/09/05 Tested on: 2013/09/06 08:36:18 AM avast! - copyright (c) 1988-2013 AVAST Software. http://www.avast.com ------------------------------------------------------------------------------ Learn the latest--Visual Studio 2012, SharePoint 2013, SQL 2012, more! Discover the easy way to master current and previous Microsoft technologies and advance your career. Get an incredible 1,500+ hours of step-by-step tutorial videos with LearnDevNow. Subscribe today and save! http://pubads.g.doubleclick.net/gampad/clk?id=58041391&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
