So does the instruction NO_FORCE_HOMING = 1 in the [TRAJ] section no longer circumnavigate this?
Also i hit a new snag yesterday while setting up machinekit gui. Up until now i have had no problems with the gui running but after changing the hal file to run my actual machine,the machine on button is now greyed out. The original Hal File used to look like this:- # this input signal must be active LOW to allow the system to energize. # this should be fed through an NC STOP type switch from DB25-1 to DB25-10 net estop-in bb_gpio.p8.in-09 => iocontrol.0.emc-enable-in setp bb_gpio.p8.in-09.invert 1 I now have the following lines in my Hal file:- newsig test bit sets test 1 net test iocontrol.0.emc-enable-in Is this not enough to enable the power button or has something been changed in there as well? The power button works fine if i switch the gui to axis or gscreen it just no longer works in my custom gui. The above changes were to circumnavigate the E-stop on a xylotex Db25 cape. On 07/02/14 04:51, Chris Morley wrote: > > >>>>> On 2/5/2014 3:49 AM, Mark Tucker wrote: >>>>>> I have been fiddling around with JT's Tutorials,in particular Gui3 shown >>>>>> here http://gnipsel.com/linuxcnc/gui/index.html. >>>>>> I can get this to run on 2.5.3 no problem,but when i try to run from 2.6 >>>>>> pre it loads up and you can take the machine out of estop but the run >>>>>> button stays greyed out? >>>>>> I have tried this on both developer machines with the same result. >>>>>> Am i missing something? >>>>>> > I assume you are using HAL_action buttons. > You can't run without being homed. > so it stays greyed out till un-estoped and homed > This is new in 2.6 > > Chris M > > ------------------------------------------------------------------------------ > Managing the Performance of Cloud-Based Applications > Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. > Read the Whitepaper. > http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ Managing the Performance of Cloud-Based Applications Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. Read the Whitepaper. http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
