correction: Am 28.02.2014 um 09:10 schrieb Michael Haberler <mai...@mah.priv.at>:
> I could imagine a firmware solution which does the link between LinuxCNC and > this board over SPI, like Gemi's picnc "outboard" - that would likely work a > lot better I dont think an SPI-based firmware solution for this board like Gemi's picnc will work well. The reason is: As Gemi found out, SPI input on AVR's is hopeless - hard to avoid input overrun. I understand this is why Gemi used a PIC. - Michael ------------------------------------------------------------------------------ Flow-based real-time traffic analytics software. Cisco certified tool. Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer Customize your own dashboards, set traffic alerts and generate reports. Network behavioral analysis & security monitoring. All-in-one tool. http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
