Here is what I have so far loadrt comp count=1 loadrt constant count=1 addf comp.0 servo-thread setp comp.0.in0 25
#setp comp.0.hyst net comp.0.in1 <= hm2_5i25.0.7i76.0.0.analogin0 net MySignal <= comp.0.out Here is the error Signal name 'comp.0.in1' must not be the same as a pin. Did you omit the signal name? Why? I obviously have some complete lack of understanding this hal scheme. On Sat, May 10, 2014 at 6:02 PM, Erik Friesen <e...@aercon.net> wrote: > Thanks, I did find it here. http://linuxcnc.org/docs/html/man/man9/ > > I find it frustrating though, I still haven't figure out how to compare a > float value and make a signal. > > This would have taken about a minute in C. Something like > > if(Value>25.0) return 1; > > > > On Sat, May 10, 2014 at 5:49 PM, Philipp Burch <p...@hb9etc.ch> wrote: > >> Hi Erik! >> >> On 10.05.2014 23:30, Erik Friesen wrote: >> > Where is one supposed to find information about how to use hal >> components? >> > >> > The hal manual has nothing more than a teaser. I am looking for info on >> > comp, one of the arithmetic "functions" >> >> Most HAL components have associated manpages, so you can usually just type >> >> man <component> >> >> in a terminal. Maybe you need to specify the manual section, if there is >> a command with the same name (such as for 'comp'): >> >> man 9 comp >> >> (It is section 9 if I recall correctly, otherwise there is a hint if you >> just type man comp.) >> >> Regards, >> Philipp >> >> >> >> ------------------------------------------------------------------------------ >> Is your legacy SCM system holding you back? Join Perforce May 7 to find >> out: >> • 3 signs your SCM is hindering your productivity >> • Requirements for releasing software faster >> • Expert tips and advice for migrating your SCM now >> http://p.sf.net/sfu/perforce >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> >> > ------------------------------------------------------------------------------ Is your legacy SCM system holding you back? Join Perforce May 7 to find out: • 3 signs your SCM is hindering your productivity • Requirements for releasing software faster • Expert tips and advice for migrating your SCM now http://p.sf.net/sfu/perforce _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users