Marius, Here is the comp file I use on my cinci 5 axis. It may give you ideas on how to make it work for you.
https://www.dropbox.com/s/rdusvaff6hh5yew/gear4.comp thanks Stuart On Sat, Aug 16, 2014 at 11:21 AM, Marius Liebenberg <[email protected]> wrote: > That's the one, thanks Andy. > > On 2014-08-16 17:45, Andy Pugh wrote: > > > >> On 16 Aug 2014, at 13:43, Marius Liebenberg <[email protected]> > wrote: > >> > >> You posted some hal code recently on how to get your spindle speed to > >> match the pulley section > > > http://linuxcnc.org/dapper/emc2/emc2/index.php/english/forum/47-hal-examples/27071-automatic-spindle-gear-detection > > > ------------------------------------------------------------------------------ > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > -- > > Regards /Groete > > Marius D. Liebenberg > +27 82 698 3251 > +27 12 743 6064 > QQ 1767394877 > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
