Hi Sebastian. I was looking at the Integrator Manual at the section that describes the motion Hal component. Il giorno 17/ott/2014 20:49, "Sebastian Kuzminsky" <s...@highlab.com> ha scritto:
> On 10/17/2014 08:44 AM, alex chiosso wrote: > > Just a note . > > The debugging pins aren't listed into the PDF doc (as I can see) . > > I was watching that documentation . > > Thanks again. > > Which document are you looking at, Alex? > > The only pdf i can see that mentions motion pins at all is this one: > > http://www.linuxcnc.org/docs/2.6/pdf/LinuxCNC_Manual_Pages.pdf > > ... And it has motion.motion-type, since it's just a re-rendering of the > motion.9 manpage. > > > -- > Sebastian Kuzminsky > > > > ------------------------------------------------------------------------------ > Comprehensive Server Monitoring with Site24x7. > Monitor 10 servers for $9/Month. > Get alerted through email, SMS, voice calls or mobile push notifications. > Take corrective actions from your mobile device. > http://p.sf.net/sfu/Zoho > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Comprehensive Server Monitoring with Site24x7. Monitor 10 servers for $9/Month. Get alerted through email, SMS, voice calls or mobile push notifications. Take corrective actions from your mobile device. http://p.sf.net/sfu/Zoho _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
