Try apt-get update & apt-get upgrade / reboot. That may be an issue that was recently fixed in the RTAI kernel.
-----Original Message----- From: Marshland Engineering [mailto:[email protected]] Sent: Friday, November 07, 2014 6:55 AM To: [email protected] Subject: Re: [Emc-users] New refit Hi Andy Thanks for the reply. I too was getting these low figures and thought I was missing a 1000 unit error. Thinking about it, something appears to be wrong. For me to manually push a 50kg table from 0 to 10m/min would take a bit of effort, but, possibly the friction/oil film takes most of the energy. I suppose 10m/min is only 0.6 kph so 10-20 watts would be enough. Why does my Anilam lathe and SWI mill use 2 kw motors ? Got my first issue. The new Gigabyte GA-J1900N motherboard bios/boot does not like the USB address and fails to load them. The mouse and both keyboard work until debian starts to load and the they both switch off. usb 1-1: device not accepting address 2, error -110 usb 1-1: new high-speed USB device number 3 using ehci_hcd It's late here so I research solutions tomorrow. Cheers Wallace ---------------------------------------------------------------------------- -- _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
