Sebastian,
You mean put "deb..." in the sources.list file, right? I did that, and
apt-get update worked fine and identified linuxcnc. Then I should do
"apt-get install hm2-firmware", right? It says package not found.
Regards,
Eric
There are two SVST4_4 bit files, one for the 400k FPGA ("big", aka "B") and
one for the 200k FPGA ("small", aka "S").
The problem you describe is a bug in the hostmot2 firmware package, which i
think is now fixed. It was due to a change in how/where the firmware debs
package the files. It's better now, but old versions of linuxcnc don't know
about the new better paths. The problem is fixed in the latest version of
the hostmot2 debs by adding back the symlinks to the old firmware locations
that i erroneously removed.
Try 0.8.21 from the hm2 buildbot:
deb http://buildbot.linuxcnc.org/hm2 hm2-firmware v0
If that works for you then i'll update the debs at www.linuxcnc.org.
------------------------------------------------------------------------------
BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT
Develop your own process in accordance with the BPMN 2 standard
Learn Process modeling best practices with Bonita BPM through live exercises
http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_
source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
