On 28 May 2015 at 12:25, Rick Lair <r...@superiorroll.com> wrote:

> then take a skim cut on the OD of the part, measure that OD,
> then enter that value into the tool table, in diameter.

I assume you mean "X" and not "D" in the tool table here?

> Then on the next part, we will MDI back to T0101, manually jog and touch
> the face, and instead off a tool table entry, we instead go back to MDI,
> and enter a G92 Z0.000,

Why G92 and not G54 (or 55 or whatever?)

-- 
atp
If you can't fix it, you don't own it.
http://www.ifixit.com/Manifesto

------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to