I don't really need to adjust the override, I just noticed yesterday, when I was running the spindle, I would give it a 1000rpm command, and the red line in the spindle speed readout bar would be centered in the little readout, when I have MAX_VELOCITY = 6000, set in my INI spindle section.
Thanks Rick On 5/27/2015 10:02 PM, Chris Morley wrote: > >> Date: Wed, 27 May 2015 14:23:08 -0400 >> From: [email protected] >> To: [email protected] >> Subject: [Emc-users] Gscreen Spindle Speed Feedback Bar >> >> Hey Chris, >> >> How do I adjust the max speed for the feedback bar, I can't seem to find >> it any where, and I am setting up the VMC I am working on with Gscreen. >> >> >> -- >> >> Thanks >> >> >> Rick Lair >> Superior Roll & Turning LLC >> 399 East Center Street >> Petersburg MI, 49270 >> PH: 734-279-1831 >> FAX: 734-279-1166 >> www.superiorroll.com >> > In the INI file under [DISPLAY] > > MAX_SPINDLE_OVERRIDE = 2.0 > MIN_SPINDLE_OVERRIDE = .50 > > That should set spindle override from 50% to 200% > > How are you adjusting spindle-override ? > If you planning on using halui and an MPG there maybe something else > you must do too. > > Chris M > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users -- Thanks Rick Lair Superior Roll & Turning LLC 399 East Center Street Petersburg MI, 49270 PH: 734-279-1831 FAX: 734-279-1166 www.superiorroll.com ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
