The front and back angles are used by Axis to display the tool in the back plot. Run the Axis lathe sim and load each tool 1-9 to see how they change.
JT On 6/24/2015 4:35 PM, Tom Easterday wrote: > Hmm, are these angles used by Axis to display the correct geometry for the > tool tip in the backplot? If so, that doesn’t seem to be working (at least > in 2.7.0~pre6). I have the Orientation and the Front/Back Angles set > (angles, perhaps incorrectly) but Axis shows the tool pointing up from below > always and always the same size triangle… > > > ------------------------------------------------------------------------------ > Monitor 25 network devices or servers for free with OpManager! > OpManager is web-based network management software that monitors > network devices and physical & virtual servers, alerts via email & sms > for fault. Monitor 25 devices for free with no restriction. Download now > http://ad.doubleclick.net/ddm/clk/292181274;119417398;o > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Monitor 25 network devices or servers for free with OpManager! OpManager is web-based network management software that monitors network devices and physical & virtual servers, alerts via email & sms for fault. Monitor 25 devices for free with no restriction. Download now http://ad.doubleclick.net/ddm/clk/292181274;119417398;o _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
