Look for DEFAULT_LINEAR_VELOCITY in the [DISPLAY] section of your ini file. If that does not exist, then there is also DEFAULT_VELOCITY in the [TRAJ] section which apparently does the same thing, but I think it has a lower priority
http://www.linuxcnc.org/docs/2.7/html/config/ini_config.html#_display_section On 06/29/2015 01:21 PM, Marcus Bowman wrote: > Sorry; I know this is an elementary question, and I have probably failed to > notice it when consulting the documentation (can't see the wood for the trees > etc). > I want to alter my "defaults" so that when LinuxCNC starts up it has a jog > speed which I have defined. The normal default is way too slow for me. I > need to set it to around 1500mm/min or thereabouts. But I can't find where > the variable lives. I don't see it in the set-up file. > > Marcus > > > ------------------------------------------------------------------------------ > Don't Limit Your Business. Reach for the Cloud. > GigeNET's Cloud Solutions provide you with the tools and support that > you need to offload your IT needs and focus on growing your business. > Configured For All Businesses. Start Your Cloud Today. > https://www.gigenetcloud.com/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Don't Limit Your Business. Reach for the Cloud. GigeNET's Cloud Solutions provide you with the tools and support that you need to offload your IT needs and focus on growing your business. Configured For All Businesses. Start Your Cloud Today. https://www.gigenetcloud.com/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
