On 07/23/2015 04:27 PM, Ralph Stirling wrote: > Have you actually measured the A and B outputs of the encoder > at 10v? I see that it takes an 8-24vdc input voltage, but I would > expect it to still generate 0 and 5v output levels. Nothing in the > datasheet seems to specify the output levels for the push-pull > output option (which your p/n has). > > Pity there isn't an actual manual for the drive available, as it also > might be capable of tolerating a voltage higher than 5v on the A+ > and B+ inputs. The datasheet doesn't specify voltage levels. > > Quite likely is is an open-collector output, meaning it will ground the output when it means for it to be low, but leave it floating when it means for it to be high. If so, then you only need a resistor to pull it up to the desired voltage (like +5V) for it to meet TTL specs.
Jon ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
