> On Aug 14, 2015, at 2:18 PM, Chris Radek <[email protected]> wrote: > > On Fri, Aug 14, 2015 at 02:07:24PM -0400, Tom Easterday wrote: >> I updated 2.7.0~pre6 to 2.7.0~pre7 via update manager in Wheezy >> and now I get this when trying to launch (rip). Is there >> something else I need to do? > > This makes no sense. If you install a package with the update > manager, that does not affect a RIP build. >
Oh, I didn’t realize that. I think this install was originally done by getting the 2.7 branch with git. I wonder why it even showed up in Update Manager? >> Error: could not load module /home/tom/linuxcnc-dev/rtlib/rtapi.ko: No >> such file or directory > > Here you are trying to run a RIP build that is not correctly built. > Nothing you do with the update manager affects this. Ok, so I went back into the 2.7 branch source “cd ~tom/linuxcnc-dev/src”, I did a “git pull”. I then just need rebuild, yes? -Tom ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
