On 8 September 2015 at 15:20, Carsten Presser <[email protected]> wrote: > 2. Illegal moves are not detected. > This is the work area: > http://i.imgur.com/CGLhgwY.png > When moving from "X0 Y-450" to "X0 Y450" the machine runs into the > hardware limit switches. > Is there any way to make the TP (or any other comp) detect those moves > prior to the execution?
Not as far as I know, and the last time I asked it wasn't possible in the JA branch either. I hesitate to suggest this, because LinuxCNC _should_ be able to do it without help, but an input filter could check the G-code and warn on out-of-limits moves. It would have to be quite an advanced filter that read the coordinate system offsets in from the linuxcnc.stat set and performed kinematics. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
