Thanks.  I realize the question was about specific Mesa choices but at one
point it was like "I have a servo, what Mesa card do I use?" Not stated was
whether there were any options.  Like "I have a servo, what's the best
servo/encoder controller out there?"
So I was curious.
John


> -----Original Message-----
> From: andy pugh [mailto:bodge...@gmail.com]
> Sent: January-21-16 10:53 AM
> To: Enhanced Machine Controller (EMC)
> Subject: Re: [Emc-users] mesa card choice and config
> 
> 
> On 21 January 2016 at 18:41, John Dammeyer <jo...@autoartisans.com>
> wrote:
> 
> > Either stepper motors and an older PC that supports parallel port or if
you
> > want servos that aren't driven with a Gecko Step/Dir input (much like a
> > stepper motor) then it's a Mesa product or nothing?
> 
> Not at all.
> 
> The Pico solutions are well supported:
> http://www.pico-systems.com/motion.html
> 
> And there is a new(ish) product line from General Mechatronics:
> http://www.generalmechatronics.com/en/linuxcnc
> 
> And the Motenc:
> http://www.vitalsystem.com/web/motion/motionLite.php
> 
> And Servo-to-Go
> http://www.servotogo.com/index.shtml
> 
> Are still supported by LinuxCNC drivers.
> 
> However, the question asked was "What Mesa cards can I use" so I
> suggested Mesa cards.
> 
> There are actually rather more options than listed here:
> http://wiki.linuxcnc.org/cgi-bin/wiki.pl?LinuxCNC_Supported_Hardware
> 
> 
> --
> atp
> If you can't fix it, you don't own it.
> http://www.ifixit.com/Manifesto
> 
>
----------------------------------------------------------------------------
--
> Site24x7 APM Insight: Get Deep Visibility into Application Performance
> APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month
> Monitor end-to-end web transactions and take corrective actions now
> Troubleshoot faster and improve end-user experience. Signup Now!
> http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users


------------------------------------------------------------------------------
Site24x7 APM Insight: Get Deep Visibility into Application Performance
APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month
Monitor end-to-end web transactions and take corrective actions now
Troubleshoot faster and improve end-user experience. Signup Now!
http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to