Can you saw the boards, like cutting thick veneer off the two faces? Just read
a bit where that was done with a tall clock door panel to preserve the original
veneered front and back finish. The thin slabs were then pressed flat and glued
to a new core that had been well dried and planed flat.
There's a job for 3D probing and milling. Probe to get the shape of the two
faces. Bandsaw as best as possible to split the warped boards then with the
finished sides down, 3D mill the sawn sides to make an even thickness yet still
warped board.
Make cores of high grade plywood and fill the gaps around the edges with wood
that matches the faces.
Which is how I might have done a lid to keep it from warping or splitting or
cupping. Not the old way of doing fine woodcraft, but neither is CNC machining.
;)
From: "[email protected]" <[email protected]>
To: Enhanced Machine Controller (EMC) <[email protected]>
Sent: Friday, March 4, 2016 8:04 PM
Subject: Re: [Emc-users] Wood expertise needed, on bending
What are you looking to do is this veneer or architectural size? In either
case you end up using many thin sections with slow setting glue bent around a
form and clamped. Sometimes steam is used
> On Mar 4, 2016, at 9:38 AM, Gene Heskett <[email protected]> wrote:
>
> Cheers, Gene Heskett
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
