Greetings,

I am attempting to assist a friend setting up a HY-JK02-M 5-axis Interface 
Board with Axis running HY-DIV168N-3.5A drivers.

Controller Manual: http://www.tecnoflexo.com.br/site/fotos/download/17/17.pdf
Driver Manual: 
http://www.goodluckbuy.com/images/detailed_images2/file/76081%20HY-DIV168N-3_5A.pdf

Actually, seems like the interface board is all properly configured, but we 
cannot get the motor to move. In the stepper config, when we go to test the 
drive the stepper comes on and holds its position. We can see the correct axes 
led indicator light up when it is commanded to move. But no motion. Axis 
launches, and the machine power button works as expected. No motion though.

I found someone running the same configuration here:

http://www.technoshamanarchist.net/?p=98

It states calculated these values:

Step time: 30000 ns
Step space: 8500 ns
Direction Hold or Direction Setup values, some people set it to 20000

But then thats all it states on the configuration and never confirms if it 
those values work or not (next post is running). We have the cards wired up 
exactly the same as shown in the pictures.

Also, in videos I have seen of the driver in action, they have two red LEDs 
lit, we only have one power LED lit, we can’t get the “run” LED on.

Any suggestions would be greatly appreciated.


Best,

Jeshua Lacock
Founder/Engineer
<3DTOPO.com>
GlassPrinted.com


------------------------------------------------------------------------------
Transform Data into Opportunity.
Accelerate data analysis in your applications with
Intel Data Analytics Acceleration Library.
Click to learn more.
http://pubads.g.doubleclick.net/gampad/clk?id=278785351&iu=/4140
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to