Yes I have used the 7i80 ethernet protocol for two cards at once. They need to have different IP and MAC addresses.
On Tue, 31 May 2016 09:36:19 -0400 Rick Lair <[email protected]> wrote: > Good Morning Guys, > > I was wondering, is it possible to run 3 7i80HD's off of one PC. > > We have an Okuma bridge mill that we just installed, and it has an off > brand retrofitted control on it, that we are having problems getting > running. When it was retrofitted they used Opto22 I/O boards, and there > are 6 of them, so I was figuring 3 7i80HD's or even 3 5i23's would allow > me to hook up all 6 I/O boards along with a 7i48 to control the servo's > and encoder feedback. > > > -- > Thanks > > > Rick Lair > Superior Roll & Turning LLC > 399 East Center Street > Petersburg MI, 49270 > PH: 734-279-1831 > FAX: 734-279-1166 > www.superiorroll.com > > > > ------------------------------------------------------------------------------ > What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic > patterns at an interface-level. Reveals which users, apps, and protocols are > consuming the most bandwidth. Provides multi-vendor support for NetFlow, > J-Flow, sFlow and other flows. Make informed decisions using capacity > planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
