On Wednesday 24 August 2016 17:31:23 andy pugh wrote: > On 24 August 2016 at 22:08, Todd Zuercher > > <[email protected]> wrote: > > I don't know that an account is required, but they at least want an > > e-mail address as payment for entry. > > Actually, it seems to be my fault, in that I copied a URL from the bar > rather than getting a sharing link. > > https://goo.gl/photos/2dwiVYxDTyD9ibti6 > > Should be visible to all.
'Twould appear to be, thanks. I see you made new castings to hide all the motors, neato! I might see if I can source some more 1/2" 7078 to make a full box as opposed to just the front panel for an apron as I can see that would add quite a bit of rigidity to the motions. But ATM the little monster is working so slowly that very few of my ideas will be finished before I'm shoveling snow. Its cutting a cone shape, centered on the off centered 10mm QC holddown bolt. With a full cylinder of cast where the compound was, the same piece for the Sheldon won't go by the cylinder at maximum x retraction. I had to cut on it for quite a while just to get it to clear the crossfeed sled. I think, by the time I get usable clearance, I'll have to change to a faceplate by drilling and tapping the faceplate to hold it off center, then write a g3 based loop to carve it in a curve to match the work piece. Either that, or drill the qc bolt hole on thru with an 8mm drill, and run a big piece of ready-thread all the way thru the spindle, with a stack of fender washers on the end sticking out. This cone will be about midnight getting done. And I'll still need to invent some g3 code to run in the xz plane. I'm not sure at times, whether I need a bigger boat, or more beer. :) Or someone to drink it with & help solve the worlds problems. My lady is going downhill (COPD) in the summer heat, dragging an oxygen hose behind her when she gets up to do anything. Sad to see too. I do what I can, & blow away swarf when I can. But I can't breath for her, dammit. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
