On 10/18/2016 03:13 PM, Erik Friesen wrote: > Is nml close enough to integrate without breaking compile on master? > > > On Tue, Oct 18, 2016 at 3:40 PM, andy pugh <[email protected]> wrote: >> On 18 October 2016 at 20:30, Erik Friesen <[email protected]> wrote: >>> Does anyone know where the source is for Keystick and xemc? I don't >>> see it under linuxcnc-master/src/emc/usr_intf or anywhere else. >> >> They were removed from Master, but can still be found in older branches: >> http://git.linuxcnc.org/gitweb?p=linuxcnc.git;a=tree;f=src/emc/usr_intf;h=4a4ba42f4673e94f168b6288024d97d3649baeed;hb=refs/heads/2.6
I'm not sure what this question is asking. xemc and keystick were removed in master because they needed maintenance, and a a call-for-maintainers did not result in anyone stepping forward. https://sourceforge.net/p/emc/mailman/emc-developers/thread/20151221024211.GF92296%40unpythonic.net/#msg34710198 If you'd like to help maintain either or both of these GUIs, i'd be happy to help point you in the right direction. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
