Best option is probably to generate stepper signal from hardware timer. 2016-10-21 8:17 GMT+02:00 Danny Miller <dan...@austin.rr.com>:
> The SPI comm of course has latency within a comm period. > > However, the pulse output must be super-fast. It supports up to 14500 > rpm, so if it's 2000steps/rev the whole step cycle is 2ms, realistically > like maybe 1/4 of that for latency? > > Danny > > On 10/19/2016 11:34 PM, Nicklas Karlsson wrote: > >>> ... The lag also seemed to vary with velocity. > >>> > >>> > >> Most specifically, it was a lag in the encoder's loop to respond to > >> acceleration. > >> Velocity was fine, but when there is acceleration, the encoder's > >> velocity didn't change for a few milliseconds, then it had to produce > >> velocity greater than real for position to catch up. > >> I thought it was a really severe problem, but it seems it may not be all > >> that bad. But, it can make servo tuning more tricky. > >> > >> Jon > > Delay is called phase in control theory and it is not good at all for > fast response. > > > > ------------------------------------------------------------ > ------------------ > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
