On 10/23/2016 09:32 AM, Jeffrey Reed wrote: > Hi to All, > I am trying get an old 64 bit Compac Persario running with LinuxCNC. > I believe I have successfully completed every item in step 7.1 in this link > http://linuxcnc.org/docs/2.7/html/getting-started/getting-linuxcnc.html > http://linuxcnc.org/docs/2.7/html/getting-started/getting-linuxcnc.html > except step 10. > Failure to install message--------------------------------------- > Some packages could not be installed. This may mean that you have > requested an impossible situation or if you are using the unstable > distribution that some required packages have not yet been created > or been moved out of Incoming. > The following information may help to resolve the situation: > > The following packages have unmet dependencies: > linuxcnc-uspace : Depends: libboost-python1.55.0 but it is not installable > Depends: libc6 (>= 2.15) but 2.13-38+deb7u11 is to be > installed > Depends: libfontconfig1 (>= 2.11) but 2.9.0-7.1+deb7u1 > is to be installed > Depends: libpango-1.0-0 (>= 1.14.0) but it is not > installable > Depends: libpangocairo-1.0-0 (>= 1.14.0) but it is not > installable > Depends: libpangoft2-1.0-0 (>= 1.14.0) but it is not > installable > Depends: libtk8.6 (>= 8.6.0) but it is not installable > Depends: libudev1 (>= 183) but it is not installable > Depends: tcl8.6 but it is not installable > Depends: tk8.6 but it is not installable > Depends: python:any (>= 2.7.5-5~) but it is not > installable > E: Unable to correct problems, you have held broken packages.
It looks like you deviated from the instructions in step 7.1.8. It looks like you're trying to install linuxcnc-uspace from Jessie onto a Wheezy machine. You can check if this is the problem by looking for the linuxcnc line(s) in /etc/apt/sources.list, it should be looking in wheezy (like 7.1.8 says), not in jessie. > I have explored Debian downloads but they do not contain the Package - > LinuxCNC. The linuxcnc packages are not (yet) part of the Debian distribution, instead we provide our own debian package archive with the linuxcnc packages. That's what step 7.1.7 and 7.1.8 are about. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
