On 12/02/2016 11:29 PM, Gene Heskett wrote: > In order to not have yafu at doing this encoder right, I have > discovered that 1. The width of the tooth of a 6" 60 tooth gear is > pi*.1, or 0.314159265358979324" per full tooth. 2. Needed is a > quadrature signal, so the center to center distance between ATS-667's is Well, I just made mine with adjustable slots, hooked up a scope and adjusted until the quadrature was about right. Now, I CANNOT remember how I spun it, as the motor had to be off to access the sensors. Might have just given it a spin by hand.
Jon ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
