On 01/03/2017 04:47 PM, dave wrote:
> Re:
> http://linuxcnc.org/docs/html/getting-started/getting-linuxcnc.html#_installing_on_ubuntu_precise
>
> The instructions for the install are nicely done. I tried it both by
> typing individual lines and  by enclosing the block of instructions in {}.
> Seemed to work either way but no joy on uname -r |  uname -a.
>
> Apparently grub does not get updated by the install and therefore one
> boots into the ...generic.
> I've pretty well worked my way thru  grub but need to weed the list to a
> generic, generic(recovery) and
> rtai.  Rtai comes up on a secondary list and I need to change that.
>
> Not complaining just a heads up. Nice to have it all laid out.

If you figure out a clear way to describe the changes needed to the GRUB 
config, an update to the docs would be much appreciated!


-- 
Sebastian Kuzminsky

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most 
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to