Re forum link below installing linux mint 17.3 64bit how to https://forum.linuxcnc.org/9-installing-linuxcnc/32140-installing-linux-mint-17-3-64bit-how-to
The other day when I tried to respond on the forum it seemed to be down so I will respond here as now it is up again I cant seem to log in. (finger problems on my part most likely) First off thanksEric282000 for sharing this and the patched kernel I followed your instructions and every thing worked almost on the first try there were just a few more unmet dependencies that I had to install before LinuxCNC would compile. Then after reboot.... uname -a. reports 4.1.36-rt42. After configuring eth1 IPV4 Settings to: Manual Address: 192.168.1.24 Netmask: 255.255.255.0 Gateway: 192.168.1.1 I can run in terminal halrun loadrt hostmot2 loadrt hm2_eth board_ip=192.168.1.121 show pin and get a list of all the pins and how they are configured. I am pretty happy!! Things are talking to each other. Now I just need some bits and pieces for this board to talk to. I am sure I will have some questions soon but thought these scribble notes may be of use to someone. Linden ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
