Hi, I have been posting on the linuxcnc forum so I can document my progress. <https://forum.linuxcnc.org/30-cnc-machines/32328-new-eagle-conversion>
I'm at the point where I can: mesaflash .. --readhmid The ports are set up for stepgen, Dir, Step. So I take it this is flashed for a stepper motor right now. Do I really need to install the xilinx design suite and write my own flash? I've looked for an off the shelf bit file but all I find are stepper files. I'd think there is a servo bit file that is suitable for what I've got. And if so, it would have a set of digital i/o's that I can just configure in HAL? Again, I'm all new to this so I'm sure my questions are dumb. Thank, Dan. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
