Normally I use io ... tb5/tb6 ...
regards Giorgio ________________________________ Da: Valerio Bellizzomi <vale...@selnet.org> Inviato: martedì 11 aprile 2017 20.25 A: EMC Users Oggetto: [Emc-users] mesa setup Hello, I am looking at the 7i76 manual and at the TB2 connector pinout (page 5), it is evident where to connect the step and dir wires, it is less evident where to connect the enable+ and enable- wires for each motor driver. What is the usual setup ? ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users Emc-users Info Page - SourceForge<https://lists.sourceforge.net/lists/listinfo/emc-users> lists.sourceforge.net This list is for users of the Enhanced Machine Controller (EMC). Topics include how to obtain, install, configure, and use EMC, as well as other general EMC related ... ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
