I'm not sure that there are any. I'll have to check what does and doesn't show. I do know that the normal example configs with 1 port run fine in the VM (VirtualBox).
----- Original Message ----- From: "Sebastian Kuzminsky" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Thursday, June 1, 2017 4:30:44 PM Subject: Re: [Emc-users] Simulations In Master? On 06/01/2017 01:22 PM, Todd Zuercher wrote: > I was trying to convert one of my machine configs to test with Master. > Testing in a VM. > > I've ran into a couple of snags though. The machine uses 3 parallel ports, > two of them in X-mode, and one as Out. > When I try to run the config I get: > Error: could not insert module > /usr/realtime-3.4-9-rtai-686-pae/modules/linuxcnc/hal_parport.ko: No such > device Do you have three parallel ports enabled on your VM? Does the linux parport driver see them? -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
