I have an issue with Pyngcgui subroutine parameter entry. I am space/resolution constrained on the monitor I use on the lathe and this results in limited space in the display of Axis’ various panels. I am using pyngcgui as tabs in Axis as well as a Glade panel on the right and when pyngcgui displays the subroutine parameters some of those parameters are actually “under” the Glade panel and cannot be seen.
You can see an example in the image here: http://bgp.nu/~tom/pub/pyngc-prob86.png Notice the circled “1” which is parameter 15 (Finish Direction). I can tab to it and enter a value but cannot see it on the screen. I have this problem with several of the routines here. I have quite a bit of vertical space and am wondering if there is a way I can force the subroutine parameters to be displayed in only 2 columns. I don’t see where I would change this in the pyngcgui.ui glade config…or if that is even where it is? -Tom ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
