will try that - thanks On Tue, Jun 6, 2017 at 11:53 AM, Jon Elson <[email protected]> wrote:
> On 06/05/2017 03:56 PM, Stuart Stevenson wrote: > >> Gentlemen, >> >> Debian Wheezy >> latest linuxcnc release - installed today - but the last release did the >> same thing >> Axis interface >> Kasuga 3 axis mill >> >> when starting (run from here) on line 310 I get the error "length of >> cutter >> compensation entry move is not greater than the tool radius" >> > The message clearly indicates the interpreter thinks cutter radius comp is > on. > if it executed the G41 on line N290 but then did NOT execute the G40 on > line N292, then it would still be in G41 offset mode. Note the displayed > modes on the GUI are provided by a DIFFERENT interpreter that is not aware > of the stop and run from line. If you need to run from line, it might be > safest to insert a line with a G40 there, and run from that line to be sure > the offset is turned off. > >> >> Jon > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
