Yes, it will probably use the same g code you see for other systems Which 10 degree angle do you want?
On Jun 19, 2017 7:29 PM, "jim" <[email protected]> wrote: > I need my machine to move On a 10 degree line using the x y axis . > > I see g codes for this on other systems . > > Can Linuxcnc do this? > > Thank you, > > Jim > > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
