On 06/24/2017 02:20 PM, Jon Elson wrote:
On 06/24/2017 03:52 PM, dave wrote:
ps. In desperation I would try axis (again) but clicking on the
sample configurations doesn't fill in the tree.
'a' and 'b' existed with the Duron also but I've never been this
stalled.
Pick any config that you like, and open the xxx.ini file in an editor.
in section [DISPLAY]
change the line DISPLAY = <something>
to
DISPLAY = axis
This should be the only thing you need to change to switch between
GUIs, as long as they don't use any exotic features like virtual
control panels.
Jon
Thanks Jon,
Tried that earlier in the day and didn't get anything.
Just tried it again and what to my wondering eyes ... axis. :-)
Still struggling with the interface but it seems to be giving me the
same errors as tk.
I can't quite figure out how I can be in the middle of the bed .... with
a small part and still
get limit violations. I suspect it is heat. The heat sink was maybe 120
F. Before I go too much farther
I will rig a fan.
Bit by bit ( maybe ) we'll get sorted.
Dave
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
