On 09.09.17 02:55, Gene Heskett wrote: > I am gradually learning how to grind HSS tooling, which is usually > sharper than a fresh carbide tool insert. That generally negates a > spring pass need after the 2nd one.
That helps, but if it's enough, then winding the cross-slide against no more load than a dial gauge will show the same 10% error as you have when cutting with the boring bar. _Then_ it's time to doubt the screw pitch, I figure. ISTR that TLM is made of cheese, based on previous experience, so excess elasticity here and there would have to be high on the list of probable culprits. (Jus' sayin') Erik ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
