https://www.mcmaster.com/#standard-socket-head-screws/=1c7nzv5
McMaster has them -- stainless only. Ken On Sat, Mar 31, 2018 at 3:32 PM, Gene Heskett <ghesk...@shentel.net> wrote: > And I don't seem to find any shorter than 10mm. > > 5mm long would be a great plenty. This is to be installed in the side of > a 7/8" diameter slug, with about 1/2 the head buried in the slug, and > the other half to stick up into a cutout the same width as the head of > the screw, purpose to lock the slug into the R8, which itself is keyed > into the spindle. With short threads, and a dot of green thread locker, > it ought to hold more torque that my spindle can muster up. If I machine > it right, for a snug fit in the slot cut in the R8 to just clear the bit > of screw head sticking out, the should not be enough slop to dislodge > the screw. > > But where can I find such short 5mm socket head screws? Need a full box. > > Net searchs show 10mm and up, too long. > > Thanks. > > -- > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > Genes Web page <http://geneslinuxbox.net:6309/gene> > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
