Has anyone here ever converted a Gerber Scientific Dimension 200 (D-200) to Linuxcnc?
It uses Gerber's ARCStation as a controller, that is connected by a 37 pin cable to the driver box, inside which is one large driver board and the power supply that drives the 3 stepper motors on the machine. I am sure that it would probably be easy to control with Linuxcnc if only I could find some clue to the wiring of the 37pin cable. That is an awful lot of wires for a simple 3 axis machine, But all of the documentation I can find has no wiring schematics, and are rather dumbed down (plug cable A into plug B...) with no real useful info. Todd Zuercher P. Graham Dunn Inc.<http://www.pgrahamdunn.com/index.php> 630 Henry Street Dalton, Ohio 44618 Phone: (330)828-2105ext. 2031 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
