That's a good price. I have tested a NUC with the N3050 cpu and it had good
latency under PREEMPT-RT, but the processor is just a tad slow. In my opinion
it would be fine for linuxcnc but might not like doing other things very well
while linuxcnc is running. I think you will need a newer kernel and all than
wheezy in order to support the hardware properly as well - jessie might work.
On 08/07/2018 08:22 AM, andy pugh wrote:
https://www.mini-itx.com/~EL-20-3050-32GB
(Reduced to £100, UK seller, so likely only of interest in the EU)
Dual LAN might make it a nice fit for the the 7i80 and friends.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
