On Sat, 1 Dec 2018 at 03:53, Thaddeus Waldner <[email protected]> wrote:
> I am using TTL step-direction outputs on the 7i96 I/O board to drive a > Teknic ClearPath motor. With the board set to TTL mode, is it possible to > address the step- and dir- pins. I would like to use one for an enable > output for the motor and the other for the feedback from the motor (input). > If you set "num_stepgens" to less than the maximum number in the "loadrt" line then the unused stepgens will appear as GPIO pins instead. -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
