Didn't have it backed up anywhere? Mark
On Sun, Jan 13, 2019, 19:47 Gene Heskett <ghesk...@shentel.net wrote: > Greetings all; > > In search of something, anything that might give me a clue as to why > about a months work on custompanel.xml was killing linuxcnc, I installed > xmlindent, and xmlcopyeditor. > > Thinking I might find a clue in the re-indented code, I checked the man > page for xmlindent. But it has only a -option for an output file. So I > ran it. Never came back, so I added the -w option. Never came back. > > Opps, now I have a zero length file where it was 130+ LOC with an error > of some sort that let it load up to the final </pyvcp> before it puked > at column 2. I can get most of it back by dragging it in from another > machine with a similar setup but to restore what I had 20 minutes ago > will take a hell of a lot longer than I have left in me for tonight. So > then I tried xmlcopyeditor, thinking I could copy/paste into that. But > its apparently only for new creation as it does not accept a paste. > WTF?? > > So where can I find an xml editor that will let me copy/paste from the > Document.pdf, most of the stuff from pages 392 on to get an rpm meter, > on, fwd, rev leds, and append align.xml stuffs to that with added status > leds to show the current machine alignment state, and which will also > show any errors (cuz the Doc.pdf has quite a few errors of its own). > > And preferably not capable of destroying several weeks worth of work over > the last 5 years? > > I know this isn't your fault, none of you wrote this stuff, but this xml > bs needs warning labels because it can destroy anybodies sanity. > > Thanks everybody. > > Cheers, Gene Heskett > -- > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
