On Tue, 27 Aug 2019, Marius Liebenberg wrote:
Date: Tue, 27 Aug 2019 21:17:19 +0200
From: Marius Liebenberg <mar...@mastercut.co.za>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: emc-users@lists.sourceforge.net
Subject: Re: [Emc-users] Pin files for 5i25
On 8/27/2019 8:48 PM, Marius Liebenberg wrote:
On 8/27/2019 1:36 PM, Marius Liebenberg wrote:
Hi all
I need to set a 5i25 up as a dual lpt port. I want to replace my
mill installation with Path Pilot and I need the pin and bit files
to do that.
Does anyone know where I can go look for the files please?
http://freeby.mesanet.com/software/parallel/5i25.zip
Thanks all. Peter to the rescue. Thanks Peter.
-
Hopefully last question. There is a load of files there and the names
makes no logical sense to me. What file should I be looking at please?
Regards / Groete
Marius D. Liebenberg
082 698 3251
The files (in configs/hostmot2) that end in .pin are text pinout files
The names match the breakout used (7I77, G540, C11 etc)
The corresponding files that end in .bit are the matching firmware files
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
