Sorry, Still confused. I'm not even sure which code you are talking about. John
> -----Original Message----- > From: N [mailto:nicklas.karlsso...@gmail.com] > Sent: February-23-20 4:00 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] about NML - RCS_CMD_CHANNEL/EMC_CMD_MSG > - EMC_AUX_ESTOP_ON > > If you figure out what code do and comment is missing you could add it. Or > you made agreement not to comment his code? > > > Not sure I understand what you meant here. > > > > > -----Original Message----- > > > From: N [mailto:nicklas.karlsso...@gmail.com] > > > Sent: February-23-20 1:12 AM > > > To: Enhanced Machine Controller (EMC) > > > Subject: Re: [Emc-users] about NML - > RCS_CMD_CHANNEL/EMC_CMD_MSG > > > - EMC_AUX_ESTOP_ON > > > > > > > @ John Dammeyer > > > > > > > > I'm quite sure that labview project at least work great .... the > > > > difficult > > > > is study lcnc code (write in a good way but not rich of comment ... on > the > > > > other hand, I agree not to comment too much on his code) > > > > > > Something adding some comments to code then you read it? > > > > > > > > > _______________________________________________ > > > Emc-users mailing list > > > Emc-users@lists.sourceforge.net > > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
