On Thursday 09 April 2020 11:49:28 Horváth Csaba wrote: > Dear Everyone, > > I have a milling machine. To this machine I connected a WXHC-HB04 MPG. > I need help for the configuration. > I operate the machine through MESA 7i92+7i33 control card. (Linuxcnc > 2.9 pre) > I set up everything. Also the MPG is operating. But if I operate it > through MPG, the axes are jerking. > While using MPG, how can I set up acceleration and decceleration in > configuration (slower acc/decc)? > This can be somewhat difficult, unless you can dedicate a button on the pendant to be an enable for a distance-per-click range adjustment using the same dial that is used for the jog in a 1,2,5 sequence. Mine starts at .0001"/click. You can dl that configuration by adding lathe-stf/ to the address bar of your browser after clicking on the link in the sig, then clicking on the linuxcnc4rpi4 link. Then dl sheldon-lathe.tgz to get the whole maryann. Somewhat messy but commented to explain what its doing. I'm useing a mesa 7i90 so you'll need to translate that i/o to your mesa cards. You will learn a lot about hal while translating that.
> Best regards, > Csaba > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
