> On Sunday 31 May 2020 17:10:10 Nicklas SB Karlsson wrote: > > > > On Sunday 31 May 2020 16:32:57 Nicklas SB Karlsson wrote: > > > > > On Sun, 31 May 2020 at 19:58, Nicklas SB Karlsson < > > > > > > > > > > [email protected]> wrote: > > > > > > Remember something about it from Uniersity but only very > > > > > > little, feed rate, surcface rougness and power requirement. > > > > > > Anybody here know anything about how to calculate suitable > > > > > > feed rate? > > > > > > > > > > FSWizard phone app? > > > > > > > > Then I need to buy a new telephone first and it will not fit in > > > > pocket, happen to know about calculator for ordinary computer? > > > > Then I could have it on same computer as Linuxcnc. > > > > > > KCalc is good. > > > > It's an ordinary calculator which of course could be of if I have the > > equations for the feed rate. > > In which case the last word on those is probably in the Machinists > handbook. And no magic there, even I can do them on a simple 4 function > model.
Found book then searching for "Machinists handbook" on internet and it look very promising. In Sweden we have an old book still printed "Karlebo handboken" and it is good, also have some pages about machining but otherwise it's mostly for mechanical engineers. Progamming I do daily though so far not in g-code so it should be less of a problem but need to figure out what program should do. Nicklas SB Karlsson _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
